GBP (£)
DPA d:dicate™ 2006A Stereo Pair with Clips and Windscreens in Peli Case
The wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
We have collected our award-winning d:dicate™ Recording Microphones in specialized stereo pairs that are matched within either ±0.5 dB, ±1 dB ±1.5 dB, depending on the pair you choose. Explore the stereo pairs below.
ST2006A Stereo Pair
Together with the MMP-A preamp this condenser mic bridges the gap between the extreme sound quality of the d:dicate™ Microphones series and our well-known Miniature Microphones in the d:screet™ series.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
| Equivalent noise level, A-weighted | Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A)) | Switchable attenuator, filters etc. | 0 dB / -20 dB |
|---|---|---|---|
| Equivalent noise level, ITU-R BS.468-4 | Typ. 28 dB (max. 30 dB) | Frequency range, ±2 dB | 50 Hz - 20 kHz with typ. 3 dB soft boost at 14 kHz |
| Relative humidity (RH) | Up to 90% | Maximum output voltage, RMS | 8 V |
| Microphone length | 164 mm (6.5 in) | Power supply (for full performance) | 48 V Phantom power (± 4 V) |
| Common mode rejection ratio (CMRR) | > 60 dB | Output balance principle | Impedance balancing with Active Drive |
| Cable drive capability | 100 m (328 ft) | Minimum load impedance | 2 kΩ |
| Max. SPL, peak before clipping | 146 dB | Total harmonic distortion (THD) | < 1% up to 130 dB SPL peak |
| S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 78 dB(A) | Weight | 160 g (5.6 oz) |
| Sensitivity, nominal, ±2 dB at 1 kHz | 40 mV/Pa; -28 dB re. 1 V/Pa | Cartridge type | Pre-polarized condenser, Twin Diaphragm Capsule |
| Principle of operation | Pressure | Directional pattern | Omnidirectional |
| Polarity | +V at pin 2 for positive sound pressure | Temperature Range | -40°C to 45°C (-40°F to 113°F) |
| Microphone Diameter | 19 mm (0.75 in) | Current Consumption | 2.8 mA |
| Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase | Frequency Range | 20 Hz - 20 kHz |
| Output Impedance | 200 Ω | Dynamic Range | Typ. 114 dB |
| Color | Matte black |
